Questions & Answers for: Konica Minolta fuser hot

Fuser is hot section near paper exit, left side, replace fuser assem. to fix, The fuser "melts toner into paper after printing", fuser runs hot at 180 deg, but yours isnt heating up, hence error, lamp

...fuser (the hot part that fixes the toner to the paper). Check if there is any sheet jammed inside your printer or if any sensor is in the wrong position. If everything seems to be ok, you may need to ...

my konica 4355 is showing f36-1 error what could be the problem Fuser Section overheaded (HOT SECTION) can be reset in 25 Mode. If it comes back Fuser needs replacement part(s)

location fuse cooling fan m1 c352 M 1 is main motor not a fan. Do you mean M 11 which fuser cooling fan located above the fuser right side of the copier above the fuser the hot part

the machine after installing the different fuser a different fuser does not reset the machine requires a manual reset procedure your old one might be ok just got to hot and shut down reset the machine

Fusing drive motor failure check the fuse the hot section of the machine REPLACE the fuser first if not that then the fuser took the motor out worse case the fuser took the motor and the control board

...is not a paper jam? Minolta 3500 Laser Printer P6 error when the printer gets hot. The only way to clear it is to turn off the machine and let it sit. Fuser issue replace the fuser (HOT ...

...fuser is not getting hot enough? Wouldn't the machine give an error code if this was the case? Or does this indicate that a sensor used in the AIDC process is faulty? What other reasons could cause ...

machine has error code c-3b02 Check the fuser unit the HOT Part. ensure properly installed. could be the fuser control board or the fuser High Current coil that part the fuser sits up against.

...heat lamp or the board that controls it. Have a tech look at the fuser? Do not continue to reset or a fire could occur and that would ruin a perfectly good day :) Code is for the FUSER!!!! (HOT