...supply. Replaced power supply now have power but get error code 6000 which i know off hand is a fuser error checked all cables still have same problem should i replace fuser? There is a thermal ...
...got hit by a surge... try the best solution on this page... c6400 is a psu failure I would do a fuser reset "u163" then try again test the voltage to see if there is power getting to the fuser ...
...and keep blinking. Second light blinks once, then all 3 top lights blink once. Repeat. Please help Fuser error (6000 error) Contact your Kyocera Mita dealer. Unfortunatly there is not much You could ...
...(FS-2020D) gives those error codes, any suggetion? when start up after self test. thanks This is a fuser error, sometimes the thermal cut out pops. Have not worked on these yet though. Definitely a ...
...roller with wires attached at each end. the machine code # 199307 It sounds to me likeit is your fuser unit. Depending on the model you can either replace the fuser drive gear or replace the
Kyocera KM-2050 Problem error C6400 Fuser unit Error code, you can try to reset, but if the code still there, you need to change the fuser unit.This is the way to reset your fuser code;On the panel ...
Question about FS 3800 Laser Printer
...(tire tracks) across every page I print. This would indicate that either the developer ,Drum or Fuser requires attention .If you stop the paper before the fuser unit is the mark there? if not
c6000 code Error C6000 is a fuser error. Solution 1: Turn it offWait 5 minutesTurn it on and the code will be clear. Solution 2:reset the fuser First open top cover then turn on power.press system ...
MITA TA180 ERROR MESSAGE C6000 Fuser heater break Fuser thermistor 1 detected less than 70°C/158°F for 10 s during warm-up and ready in. During warm-up, the temperature at the fuser unit thermistor 1 ...
Question about FS3900DN Fuser Fixing Unit - 120 Volt Genuine
How do I change out the fuser fixing unit on a Kyocera FS3900 DN 1. Draw the rear unit. 2. Insert a flat-blade screwdriver to push the fuser lock (gray colored) on the rear unit and the fuser unit is ...
Usually answered in minutes!
180 Questions
128 Questions
77 Questions
66 Questions
63 Questions