Questions & Answers for: GMC Safari fusable link

Lose power to half of the systems My 1994 Safari Van turns over but would not start. Headlights and radio would not turn on but heater fan worked fine. Set for a couple of days and started fine with ...

Need help replacing fusible link connector I need to replace the fusible link connector (off the battery) but don't remember which wire goes to which fusible link. The connector pins are labeled A,B,C

I have a 1994 Safari. I have removed the fusible link connector (at the battery) and cut it out of the wire harness. Now that have the new one I don't remember which circuits go to what fusible links.

...fusable link at the starter is broken If the fusable link at the starter is broken would I have no power going to starter but power at the switch? 1999 gmc safari if just the starter fusible link is ...

There are two wires with no power at starter. The one with the fusible link and the wire going to the start. would the fusible link being burnt cause the other wire not to have power? The starter is ...

Play in steering and rough riding when stopping or slowing down I have a 1996 GMC Safari Van they tell me it needs a Drag Link. Is this difficult to repair and could I do this at home? Could it be ...

...fusable link in my van is, I'm not getting charge from the Altonator . New altonator starter went out and changed it then battery was reading low charge bought a new one because previous on was bad . ...

diagram for the fusible link for the fuel pump for a 1997 safari It is located coming off of the starter,along with the large battery cable,pull on the fusible link,if it pulls apart like taffy,then ...

...fusable link wire or possibly the ignition switch down on the column is out of adjustment. If you have a tilt column try moving up and down all the way to see if it will start if it does your switch ...

...a charge should be 12-13 volts not disconnect negative from battery and put your multimeter on fusable 10 amp and do a draw or drain test plug the black cable from the multimeter to the battery ...