...furnace wont ignite I have a fairly new (10 yrs old) janitrol furnace which wont ignite it goes through all the motions trying to ignite but after about 2 to 3 minutes there is a hissing noise that ...
Question about Propane Forced Air Heater w/Electronic Ignition (50,000-80,000 BTU)
...wont ignite all components of my furnace work except the pilot light wont ignite the burners, this is an older electronic ignition furnace made by carrier. unless you are well trained in ...
...furnace not hard but before replacing check pilot light and thermocouple for proper function and setting if pilot light not in right position thermocouple wont open gas valve if electronic ignition ...
Question about GPG152407041 15 SEER Packaged Furnace and Air Conditioner
...furnace keeps shutting down soon after burner ignites inducer motor stays running wont heat until reset switch behind inducer motor is pushed Sometimes a "Flame Sensor" gets carboned up and does not ...
Question about GMVC80905CX Gas Furnace
...furnace goes through the cycle but wont ignite. I have already checked the ignitor. Have already changed the limited pressure switch. Furnace runs normal cycle turns on heats up lets gas out at the ...
Question about Intertherm Furnace Motor 1/8hp 1050 RPM 2-Speed 115 volts 90
intertherm furnace has no flame furnace will kick on but wont ignite-theres no flame It has an ignition control problem. Check the ignition transformer, relay, and the fuse.
Question about Intertherm Furnace Motor 1/8hp 1050 RPM 2-Speed 115 volts 90
...furnace gmh95090cxac wont stay lit keeps clicking will lite then clicks back off what would be the problem the glow rod will lite then go dim a number of times then the burners try to ignite but wont ...
Question about Intertherm Furnace Motor 1/8hp 1050 RPM 2-Speed 115 volts 90
...Furnace will start up and heat house, but then wont relight until you turn off or move thermostat again. The fan keeps running after it shuts off. If this is a hot surface ignition system, the sensor ...
Question about Intertherm Furnace Motor 1/8hp 1050 RPM 2-Speed 115 volts 90
...furnace ran out of propane and now wont ignite it has an electric igniter that is glowing red but no propane to ignite Check along the gas supply line to the furnace and make sure there isn't a valve ...
Question about GMS90703BXA Heater
...furnace it ignites fine but the blower wont kick on ignites fine but theblower wont come on main fan should come on once furnace has heated up to supply hot air to the house. make sure proper voltage ...
Usually answered in minutes!
378 Questions
257 Questions
252 Questions
238 Questions
190 Questions
