...fuel level sender units in the fuel tank (there are two float units, one with the fuel pump). Located under the rear pass seats on the driver's side and another on passenger side (seats need to be ...
fuel sender, or a bad fuel sender. If it was just a broken wire, it would read empty instead. The fuel sender is a permanent part of the fuel pump, so that has to be replaced as a unit. General Motors
...fuel sender assembly. Note the position of the fuel strainer (2) on the fuel sender. Support the fuel sender assembly with one hand and grasp the strainer (2) with the other hand. Pull the strainer ...
...fuel sender module assembly is mounted in the fuel tank (click image for zoom) Relieve the fuel system pressure. Refer to procedure in this section. Disconnect the negative battery cable. Drain the ...
Question about 2000 Malibu
...like that I guess knowing the diagram would be the best soo plz hel[p me check power to the sender unit in the fuel tank may be a break in the wire in your trunk/boot. if not change the sender
Question about 1990 Ramcharger
...sender first its cheep to buy the fuel gauge can be hard to fix you need to get a diagram and ground the gauge wire if the fuel lvl gos to full then its the sender in the tank and thats a tank down ...
...fuel sender in the tank is bad. It is possible that you have a bad gauge. The only way to tell for sure is to get to the tank sender and ground out the wire leading to the connector. This is more ...
Question about 1995 Montero SR
...fuel float sender is stuck or damaged , also in rare cases the wire to sender/tank can become damaged and short to ground making a false full tank appear (use flashlight and look carefully at under ...
Question about 1995 Montero SR
fuel sender unit (part of the fuel pump module). This is a variable resistor which varies the ground supply to the gauge. When the fuel level is low, the resistance is low, when the fuel level is high
...it does the in tank fuel sender unit needs to be replaced. If the gauge doesn't move then the fault is in the wiring or the gauge its self. Sender units tend to be the problem with this type of
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
