Questions & Answers for: Ford Focus fuel pump driver module

...fuel pump ( a slight whirring and then it'll stop when the pressure is up). If the fuel pump is pressurizing the system , maybe you should consider replacement of the fuel filter ( located on frame ...

Ad

Question about 2003 Focus

2 Answers

fuel pump, fuel pressure regulator, fuel filter, fuel supply line, fuel rail, fuel rail pulse damper, fuel injectors, and schrader/pressure test point. Operation of the system is as follows (Figure 62

Ad

fuel pump What Needs to be done is First Check The Inertia Fuel Shutoff Switch Located Behind the Driver side (KICK Panel) Witch is @ your LEFT Ankle When sitting in a Driving Position. If it"s ( OUT

fuel pump driver module and still car will not start? 2000 ford focus 2.0 sohc se. the damn car will not start still!!! the car turns over but will not start or stay running. need answers ASAP!!!!!!!!

...fuel pump secondary circuit FD driver module. What you need to do is check the voltage at the fuel pump. Hook your meter to the fuel pump and have a helper turn on the key. You should see voltage for ...

...fuel system . There is a fuel pump driver module which controls the fuel pump with PWM .pulse width modulation. Ford Electronic Returnless Fuel Systems Clip P0190 Fuel Rail Pressure Sensor ...

fuel pump after trblshooting the vehicle would run at idle if started with a id of carb cleaned down the throat. Thw new pump required a mod to the tank removing the orriginat pump mount on the bottom

2000 ford taurus code p1237 car shuts off then restarts The code is for the fuel pump circuit - possibly a faulty fuel pump driver module. The circuit would need to be tested.

Question about 2000 Focus

3 Answers

...fuel pump not working 3 door car no noise from pump when switching ignition fuses and relay fine There should be a reset button on a part called an Inertia switch. This switch is located behind the ...

Question about 2004 Focus

1 Answer

fuel pump driver module DOHC 2.0L engine. Cranks, strong spark, no start. DTC 1233 indicating Fuel Pump Driver Module (FPDM). Replaced FPDM and car started up immediately. Ran for about 15 minutes ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,749 Questions

2001 Ford Focus
2001 Ford Focus

2,612 Questions

2003 Ford Focus
2003 Ford Focus

2,055 Questions

2005 Ford Focus
2005 Ford Focus

1,226 Questions

2004 Ford Focus
2004 Ford Focus

897 Questions

Manuals & User Guides

Loading...