Questions & Answers for: Jeep Liberty my fuel injector

...fuel injector for cylinder #2. Check resistance of this injector and compare the reading to another injector. replace if needed There may be an issue with your fuel pump relay or its wiring. however ...

...the fuel injector in most cases when the number 1 injector goes bad the other injector have the tendency to misfire. Also you need to check the fuel pressure to see if is to low due to a dirty

...fuel injector on a 2002 jeep liberty 3.7 so that mean the old one is all ready removed.? or did you mean all steps in the fsm for INJECTOR. the steps are the same on all EFI fuel rail injectors. you ...

...fuel filter Check injector pulse to make sure the computer is commanding the injector on and off. Check that the plug isn't cracked. Check cylinder compression if all ok you may need and injector ...

...Fuel trigger is check with a noid light. The injector gets unplugged and the noid light gets plugged in to the injector clip. With the engine cranking over, this light must blink. This is the signal ...

no power to the left side fuel injectors fuel injectors not getting power on the left side tryed the light test to all six and there is constant and pulse power to the right side but nothing from the ...

...fuel injector 1, when I press on the gas to pick up speed the car bucks and when it is idle there is a hard shake and the malfunction indicator light is on. It blinks when I drive but if I am idle it ...

...Fuel Injector System for the '02 Jeep Liberty? there is a 100s of pages for electrics in the FSM> or at alldata.com but you must know what engine you have first. what kind of diagram. there are ...

...fuel injector that seals it to the fuel rail hes failed. You need to remove the fuel rail and change the O ring. Use Viton O rings for sealing gasoline. Lube the O rings before reassembly, should go ...

...FUEL INJECTOR WIRE PIN LOCATION TO TEST FOR BAD WIRE I have a 2004 Jeep Liberty with the 3.7 V6 it says that the number 4 injector has an open circuit how do I fix this problem I've already changed ...