Questions & Answers for: Crown front speaker

...the amp driving subs at the back of the room facing say for the example full range speakers at the front of the room, then you would need to invert the signal to prevent phase cancellation

...speaker of the bass works wich is channel 1 channel 2 does not work and fault button keeps on blinking red? The XTI 2k has lots of DSP options built into the front panel. If it's your intent to run ...

...front and rear panels are unobstructed. â?¢ Severe overcurrent conditions: This occurs whenever the signal being input to the S1500 / S2000 rises to a level above 20% THD (Total Harmonic ...

...related. space them out so they r not side by side in the rack/?/?.....extra fan in back/???...or front. can i change the sensitivity?...or is it set to protect the circutry?? It IS set to protect ...

front (Power, Fault, Clip 1, and Clip 2) flashed simultaneously with the sound. It lasted for maybe 2 seconds tops. Immediately following, the unit powered off. All four led indicators are off at this

...to me - in older days specially lots of european amps the solution is a equalizer on the front and equilze it smoth how u want ...

...Front Speaker Positive Wire (+): Pink Left Front Speaker Negative Wire (-): Violet Right Front Speaker Positive Wire (+): Light Green Right Front Speaker Negative Wire (-): Blue Left Rear Speaker ...

...speaker relay or whatever on the amp has bailed out. Good Luck :) R Check the grounding screws on the main board the one in front of the right heat sink has a solder ring on the bottom make sure it's ...

Front Speaker Wire (+): Gray Left Front Speaker Wire (-): Yellow Right Front Speaker Wire (+): White/Red Right Front Speaker Wire (-): Brown/Red Rear Speakers Size: 4? Speakers Rear Speakers Location: