Question about 3hp Whisperflo Pool Pump In - Ground
...as if the impellor is not seated properly. Any suggestion? Their is a wear ring that goes on the front of the impeller. Be sure that is there and on right. Most people will put this on with the ...
...the inlet/outlet (headers) is removed with i think 4 phillips #2 screws. Romove that, open the front right panel. Find the thermistor on the header (i will post a manual below so that you can ...
Question about White/Gray Legend Platinum Automatic Pool Cleaner - Ll105pm
Front wheel gear not engaging My front left wheel is not turning. Upon closer inspection, I found that the gear shaft is engaging the front right wheel in the grooves of the wheel but does not engage ...
Question about PUREX MINIMAX HEATER; THERMOSTAT, 60 CAPILLARY - 072022
where is the pilot light on the minimax pool heater 400 down under by front by burn tubes follow small silver tube from gas valve has red and white wires to gas valve take picture before removing if ...
Question about White/Gray Legend Platinum Automatic Pool Cleaner - Ll105pm
pentair legend front wheel does not turn right front wheel turns left front does not, are both supposed to turn? remove cover and adjust wheels to gear or if stripped switch front to back
Question about White/Gray Legend Platinum Automatic Pool Cleaner - Ll105pm
the front tires don't stay on the bottom when running the front tires don't stay on the bottom when running A broken float (water in the float) can cause that.
Question about White/Gray Legend Platinum Automatic Pool Cleaner - Ll105pm
letro legend front wheel drive wheels no moving take top off and adjust front wheels closer to gear but not too tight
Question about White/Gray Legend Platinum Automatic Pool Cleaner - Ll105pm
Pentair front wheels not turning make sure the inside of the wheels arent stripped they are gears if loose take apart adjust out so they touch the other gear that should fix that if gears are stripped
Question about White/Gray Legend Platinum Automatic Pool Cleaner - Ll105pm
...to be more accurate. If you have no way to hold the lid on to get suction, you have to replace the front bowl (pot) as that is where the strainer basket is and how the flow is created. That bowl
why will pump not prime You have a suction leak, either on the front of the pump, pump housing, O-rings or seals. There can also be a cracked pipe from the front of the pump forward.
Usually answered in minutes!
337 Questions
104 Questions
92 Questions