Washer won't run.... I tossed a comforter in this afternoon and found that it wasn't spinning and rinsing like it should. It just stopped spinning or rinsing but the timer on the control panel still ...
Question about GLTF2940ES Front Load Washer
...Frigidaire Gallery Series front loader washer for 4 years now. I loved it when I first got it but then began to have all of the problems described in these posts. I had several service calls and was ...
...Frigidaire washer (E70) as bubbles100. I called an appliance repairman on 5/14/09 and paid him $60 to tell me my hot and cold water hoses were reversed/not properly installed. This repairman was the ...
Question about GLTF2940ES Front Load Washer
1 minute and would not finish cycle. Finally got the washer to stop and open, but it does not work anymore. I turn it on, the door locks and it acts like it will work. A little bit of water comes out
Question about 24 in. PLD3465REC Stainless Steel Built-in Dishwasher
...washer, and leave it loose through a cycle to verify that this is your problem. i am having the same problem but i can't seem to figure out how to fix it. it's not reseting? what else could i do ...
Question about Affinity ATF7000E Front Load Washer
...1/2 yr old unit stopped working completely at almost the end of the cycle. When I went to take out the clothes they were still wet, thought it was the spin cycle so I tried that and the machine ...
Question about Professional Series 24 in. Built-In Dishwasher Dishwasher
...1 gallon of white vinegar for your wash after you clean the screens. Start your washer to fill with water but after the water starts, open your door and pore all of the gallon in the unit. Let it now ...
Question about Affinity ATF6000F Front Load Washer
...Frigidaire washer is powering on but is not operating. It sounds like you could have a possible problem with your control panel. You may want to check if the panel is locked. If it is locked you ...
Question about Affinity ATF6000F Front Load Washer
...Frigidaire washer, GLTF2940FS1, stopped with 1 minute left in your cycle. This could be a potential issue with your door latch, control board, or a miscommunication within your washer. I would ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions