Questions & Answers for: Ruud where does the freon go in at

go outside and push the high pressure reset button the unit will start and continue to run. I have had it cleaned and checked for freon. They also changed the fan motor and drained the freon to see if

High side low side pressures don not respond to freon levels I have a new 2stage Ruud heat pump. It runs well in cooling mode but makes a rumbling noise in heat mode. The rummbling noise is in sync ...

...liquid going back into compressor . Makes very loud knocking noise. Has scroll compressor with 410A freon.Does find except when defrosting. Well you may want to have a tech come out and check the ...

...condensor unit outside) 2 years old, last few months not colling well. This could be due to a freon leak or the condenser unit needs cleaning also the evaporator in the attic should also be ...

...go outside and hit a button on the back bottom of the unit. Once we do that it will blow hot air for that cycle. when it is time for it to come on it is cold air again and the unit outside is not ...

pipes froze outside with ice, no cold air comming into the house You are low on freon. Which most likely means that you also have a leak going on in your system somewhere. This task is best left to a ...

...on it. I am taking for granted that the unit was working if so it sounds as if the unit is low on freon. your inside coil should be sweating a lot from top to bottom if it is only cool or sweating ...

go out is the capacitor its a canister that wires plug into it controls the fan and compressor or both after insureing that everything works you can check freon and getting your superheat reading will

...go into a vac on the low side gauge. When running on a full charge, it will be on about 64 p.s.i. at 95 degrees outdoors. If is low on gas/freon, it will pull down to around 20 p.s.i. which is the ...

...freon with no explanation as to why this happened. I am sick and tired of this unit and want to ask for a replacement unit. It is still under warranty until April 2012. The repairman is due to come ...