Questions & Answers for: freezer door bulge

freezer and cold food temps If you could look around the door panel for a model number, Example:106.48062890 I may be able to help you solve the problem. Causes could be defrost timer, defrost element

freezer is running good & doing its job. He said the only problem I have is with the door gasket which doesn't seal properly. I ordered another one & installed it but that one also didn't seal

...freezer side and close the door, that in itself will push the refrigerator door open. Is it because the magnet inside the rubber gasket around the door are no longer strong or what? It shouldn't be ...

...door. Help! What causes this and how can we fix it? The fridge still cools well and the freezer side is not affected. Hi, Check out these tips...they can help you figure out whats going wrong with ...

...door closes ok but still concerned as to why rear inner panel is bulging. Freezer appears to be function normally. HELP! Unplug the unit and take out all the drawers and remove the back (behind the ...

...door LFX25960? How to reset display panel that reads error message: Er IF To reset is to repair, this error message it telling you that your Ice Fan is probably not running which is contained in the ...

...door LFX25960? How to reset display panel that reads error message: Er IF To reset is to repair, this error message it telling you that your Ice Fan is probably not running which is contained in the ...

...freezer level, door closure, and power (plugged straight into wall). All were fine. Tried to reset panel built panel locked so unresponsive to any button presses. Nothing in manual about this. Try ...

freezer door there are three racks from the bottom of the door up. Just above the third rack there is a bulge in the door where the ice chute is and the motor is at the bottom of that bulge looking up

...freezer door seals or door not closing. fridge gets cooled from freezer. not so common, control board, compressor. control board may have bad capacitors (bulging) compressor may be better to replace ...