Questions & Answers for: form alignment


Question about HP Computers & Internet

1 Answer

...alignment form every time I start the ptinter. I don't want it except when I change cartridges. How can I stop the unwanted printings of this form.??? check your settings. it might be set up to do a ...


...alignment form when not needed Still can't figue out where "settings" you mentioned can be found in HP solution software or instructions, let alone in Windows XP. Have found I can keep printer (HP ...


Question about 4247 Model V03 Matrix Printer

1 Answer

...on the right. When I adjusted the tractor feed to the right for printing, I keep getting a load forms message even though the paper is loaded. Pushing start only advances another page and then

Question about X6170 All-In-One InkJet Printer

1 Answer Align your cartridges to solve print quality problems such as: ? Characters are not properly formed or are not aligned at the left margin. ? Vertical, straight lines are wavy. 1 Load paper in ...

Lexmark Z2420: How to nudge margins to align a form Lexmark Z2420: How to "nudge" margins to align a pre-printed form so the boxes are filled in correctly. CMS 1500 health insurance form Thanks Go ...

Question about 2380 Plus Matrix Printer

1 Answer

How do I align the top of form position & for adjusting printing position on my pre-printed form? Make sure continuous forms are in the printer. Press Alt and then press Setup to enter Setup ...

Question about PIXMA iP1200 Photo Printer

1 Answer

...a cartridge. However, you may also need to align cartridges when: Characters are improperly formed or are misaligned at the left margin. Vertical, straight lines are wavy. From your ...

Question about 1990 F150

1 Answer

...tool that can be purchased at an auto parts store. Basically it is a piece of plastic that is formed in the shape of a transmission shaft. After all the pieces are aligned and tightened down, ...

...the crankshaft sprocket does not seem to be aligned and not at TDC. follow this Survey Scanning Form Scanning Software AutoData ...

My machine is picking up the bottom thread but stitch is not formed. I have a Ming Hui sewing machine. The hook- needle alignment was off and so I aligned it. Now the hook is going through the loop ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Computers & Internet Experts


Level 3 Expert

85241 Answers

Brad Brown

Level 3 Expert

19165 Answers

Cindy Wells

Level 3 Expert

6556 Answers

Are you a Computers & Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides