Question about 2005 FXDL - FXDLI Dyna Low Rider
...fork slider. fill through the top of the forks. be careful the inner springs of the fork tube are under compression when you remove and replace the fork top nuts. installing the fork nuts will take ...
Question about 2005 FLSTC - FLSTCI Heritage Softail Classic
...fork tube. Remove the screw and remove the lower slider. It is quite a bit messier as all the oil is not out of the slider when you take it off. When you reassemble, make sure you use the proper ...
Question about 2005 FLSTN- FLSTNI Softail Deluxe
...slider by removing the fork tube plug and removing the spring. To get to this plug, you'll probably have to remove the windshield, the nachelle, and the top cap. Then loosen the clamp bolt in the ...
...You need to turn the fork tube upside down and find the socket head bolt in the hole where the axle goes through the slider. Take the bolt out and the upper fork tube will come out of the slider. ...
How to replace lower forks on a '96 How to replace lower forks on a '96 Hi Kkovacik88, please visit the websites below and good luck: REPLACING STOCK HARLEY DAVIDSON FORK SLIDERS WITH CHROME ...
...slider off fork tube. Take slider to bench and remove internal snap ring and carefully pry the old seals out without damaging anything. Grease the new seals and carefully tap seal into slider evenly. ...
Question about 1996 RVF 400 NC35
fork fluid level on original slider fluid measured 1.5 inches from top of tube manual state should be 4.3 inches witch is right If I put the fluid level to 1.5 will I damage anything was that with the
...fork tube or slider is bent or damaged it must also be replaced now, replace all other worn or damaged components if and as necessary. To assemble a 2007 DYNA fork FIRST insert the seat pipe assembly ...
...fork slider (not the fork tube) into the fork tube holder, install the drain plug at the bottom of the fork slider, if it had been removed and tighten the plug to 72-96 in-lbs (8-11 Nm). MODEL FORK ...
...fork slider to prevent the fork from dropping, remove the fork cap bolt from the fork tube plug and slide the fork tube down and out of the upper fork bracket, the fork stop, the lower fork bracket, ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions