Questions & Answers for: ford 500 throttle sensor

...ford ranger when i start it it will idle at 1 rpm and its rough and then it drops to 500 rpm and it sound rougherand then there gas spitting out of the exhaust and i am gettin terrible gas milage i ...

Ford 500, if I don't put it in drive or reverse immediately, the Throttle Control/Transmission light comes on, and it will only drive in a low gear. I have to stop the car, park i when starting my

...ford ranger when you try to accelerate from a stop it loses power but runs fine once it gets going. Plus now when in park it will not stay idoloing it will start out at 1500rpms and then slowly cut ...

.tranmission www.justanswer.com > Ford I have a 2006 Ford 500. It kicks in to "limp mode" occasionally. There does not seem to be any other issues with the tranmission other than this. Do I have to ..

...ford 500 awd v-6,my car only goes 45miles an hour. i just need to make sure where the camshaft is located to get the job done not a cam position sensor if it was , the engine would not start possible ...

500,#2coil primary/secondary unit malf.circuit low input intake air temperature sensor circuit hi input throttle actuator control sytm forced lmtd pw P2106 Ford Throttle Actuator Control System Forced

Can you put a throttle body sensor from a 2006 Ford 500 sel into a Ford 500 sel 2005 shows to be the same part number c 7012196585mtr for both

...Ford 500 with codes of p2135 and p2106. I cleaned throttle body and light went off for a day. Just replaced throttle body is a new one and light came back on. What are my options? how do you adjust ...

Ford 500 Try forcing a reboot. Disconnect th ed battery for several minutes and this should clear the memories. Make sure the wire plug going into sensor is connected properly and plug did not get any

Ford 500 wrench light? I've replaced wiring harness and throttle body. With no results. Please help You need a Code reader Scan tool and read the codes. The code gives you the reason and the fix. Five