Questions & Answers for: foot down adjustable bed

...properly then drive it with the handbrake pulled up until you hear the engine rev's go down. Let the handbrake off and ter the foot brake. You should have brake's. Hope this help's it works for

foot is down during the threading, the tension control is closed and the thread cannot enter as it should. No tension control of the top thread and the bobbin thread cannot connect for a proper stitch

...foot). It just slowly sinks back down. Hi. Most likely a faulty switch in the hand piece. I had a hoist in for repair the other day doing a similar thing. The down switch was being pressed by the ...

...down into the tension disks. I pull off about 2 foot of thread from the spool and put my right-hand finger on the thread very close to the spool (the idea is to hold it down so it doesn't move) then ...

...foot, thread the needle and then advance the balance wheel slowly so that the needle goes down and then returns up. If the machine is correctly threaded, correctly adjusted , has an unbent needle and ...

...foot UP not down. This will allow the top thread to engage properly in the top tension disc Hello there, Have the tension adjusted correctly and the thread and the thread will no longer get tangled. ...

...Down Lever Drop Feed Dog Declutch Bobbin Winder Snap (clip) Presser foot Built-in Needle Threader Thread Cutter Thread Take Up Lever (****) Horizontal SpoolTry looking clicking in the previous links, ...

...down in the rings. (make sense)  Fit your hoop on the bed of the sewing machine, under the presser foot/presser foot bar.  Lower the presser foot lever. (important for tension)  and ...

...foot goes up but together. entire bed should go up and down all in one motion. Assume timing bar is out of sync, how do we fix that? your question was put in the sewing machine catagory,,you might ...

...foot go up and down. I don't know which model it is, but it's about 5 years old and the mattress is the basic, cheapest one. I checked all batteries and made sure I rebooted as always needed and it ...