Questions & Answers for: Homelite fly touch

I need the gap dim between the fly wheel and the mag. Thanks , Rudy Sorry ! The saw is a 16'' super 2 .010 of an inch

hard to start and keep running mighty lite 26ss This trimmer has been a problem from the start. I have to use an almost full choke to keep it running at all. When you try to give it the gas the motor ...

...is froze but when I pull the pull rope cover off the pull rope pulls freely and I can turn the fly wheel by hand easily. Put everthing back togeather it will not pull. PISTON COULD BE SEIZED DUE ...

flywheel to mag. clearance 330 homelight chain saw Ignition module gap Place a business or index card between the fly wheel and coil, rotate until the magnetic attraction pulls everything tight ...

It runs for 1 minute and stops. I replaced the spark plug & cleaned the vents. As I was flying by your page, I’ve noticed that you have not heard of a better and safer method of cleaning out your ...

...pulling starter rope , it has a strong pull back on your hands. the point gap is correct, and the fly wheel key is not sheared or broken. check the clearence on the stator between the pull cord ...

...my pullrop works fine, comes out and goes back in, but there seems to be no connection with the flywheel, it just spins out and back in, i don't get it... i did notice that on the rope wheel

i have ut 10519 cant get a spark. I have replaced the plug ,the ignition magneto twice, the fly wheel has good magnetism,and the distance between mag and fly wheel is set to a playing card width. ...

REPLACED PLUG BUT STILL NO SPARK FROM COIL The first thing I would do is replace the points and condenser. These parts may be under the fly wheel or just outside it.

...1 check your comprassion ratio on the cylinder , 2nd fuel hose broken or blocking the fuel 3th or fly whell key broken, start with new spark plug on 2 stroke engine 4th check for exhaust blokage