Questions & Answers for: Ford Contour floor console

blower does not go to proper position when i turn the blower selectoe swith to panel,floor,or any other position, the air is not directed properly. replace blend motor

...floor console screws. Move seat fully forward. Fully apply the parking brake. Detach the shift indicator selector bezel. Detach the shift bezel from the selector housing. Remove three bolts. Detach ...

in how do i put tank back in please help it does require some patience truly relax and the use of a floor jack is most helpful and maby even a 2x4 i assure you it does fit ....a tough job when working

...located at the bottom of the engine then i"d advise raising the car safley with two stands and a floor jack...i never work with out this set up because i had a floor jack creep down on me once. ...

I HAVE A 99 FORD CONTOUR, THE AIR FLOW BLOWS ONLY FROM THE DEFROSTER NOT THE FLOOR OR VENTS look under the hood and dash for broken vacuum lines as that is what as that is what actuates the air flow ...

...floor console. For additional information, refer to Section 501-12. Floor Console - Vehicles with Automatic Transaxle Removal WARNING: Wait at least one minute after disconnecting the battery cables ...

The emergency brake handle in the center console is being obstructed by something that has fallen into the console. How can I take the console off so I can clean it out and free the brake handle's ...

floor then the switch will be in that console next to the gear shift but you will have to take the console off to see it. I would definitely check both of these items if your sure the battery is fully

no hot air heat to floor on 2000 ford contour switch from defrost to floor air comes out panel vents you could have a bad switch, the vacuum lines could be leaking,  or your blend door could be ...

...the heater will not have a drain hose but the evaporator for the ac unit will have . Pull the floor mat back under the ac box and you will see where the drain hose goes into the floor ...