...spring, replaced float valve and cleaned carburator. Will run with float valve off, but will only run a few seconds with float valve on. make sure when you put bowl back on carb the float isn't being ...
...float problems, that has done it since new, waiting for spring to remedy. Good luck, Also you can go to Karcher.com for a parts explosion and manual if needed. Drain the oil, remove and clean spark ...
...them later if you don't need them. :) Here is what you need to do: 1. Fuel selector off 2. Remove float bowl mounting screws and nut 3. Remove the BRASS Jet / Orifice in the very bottom of the ...
float arm where the spring will be in the right postion for installation.The spring will set in the indention and you will install the float arm with the needle/float valve and float rod into position
Usually answered in minutes!
685 Questions
273 Questions
123 Questions
72 Questions
36 Questions