Questions & Answers for: kawasaki float setting

Carbies willn't set float level,right floods,left sets to low Carby floats don't set.Removed several times & adjusted the floats. It doesn't change the fuel level in the carby bowl. Checking this by ...

KDX200 carb float set up. Hi I have gas coming KDX200 carb float set up. Hi I have gas coming out of the float chamber overflow so obviously need to set the floats but would like to know how to do it ...

Its not a problem, I need to know if there is another way to set/measure the float hights without the need of the speacial Kawasaki tool for doing so? I understand the hieght should be set at around ...

float setting in the carb. I don't know what the specs are for the setting. Does any one know what they are. The float highth is .74" + or - .07" A bit of additional info, now that the unit is in bits

I had a fuel leak from carb. Took off Throttle body & adjusted float to stop leak. Don't have proper air fuel or float settings. For Float setting try about 26 mm using std main and idle jets

1985 Kawasaki GPZ600 carby flooding engine when Kawasaki GPZ600 carby flooding engine when stopped, float needles look ok, all float levels equal. sounds like the float level is set to high and it is ...

i need the specs for setting the floats and jets on a 1986 kawasaki gpz 1000 The float setting is 17mm frombase of carb to farthest edge of float ,holding carb  vertical

...to the carb but it floods and will not get gas to the cylinder at all A couple of possibilities- - Float is corroded and not floating - Valve either gummed up or worn and stuck - Float level not ...

How do you set the float levels on a 1987 gpx kawasaki.are these bikes reliable. Mine will start but when you turn the fuel on it starts flooding. Can the floats be adjusted or is it better to try to ...

...for about a month now when u turn on fuel it leaks out if the over flow tube what could cause this Floats not set right. Float needle worn. Dirt keeping float needle open. Clean out carb, adjust ...