Questions & Answers for: GMC Yukon flex plate

...like to replace the air conditioner belt on my 2002 Yukon myself. I have the 5.3 liter 8 cylinder flex fuel Yukon. I replaced the serpentine belt last week and that is when I saw the AC belt down

Ad

1999 GMC Yukon aft door will not lock. I have 1999 GMC Yukon aft door will not lock. I have looked at the door connectors - there are five brass buttons on frame side and only four brass plates on the

Ad

2003 yukon with flex fuel engine is stalling out. its like it looses its prime. Got under it and listened to fuel pump and it made a sound like a pully or barring thats going out. It sounds like you ...

Question about 2003 Yukon

2 Answers

my 5.7 liter flex fuel will start sometimes, will rev up to 1,000 rpm, then drop to about 300 rpm and run rough before shutting off a few seconds later. intake manifold gasket leak messing with ...

Question about 2000 Yukon

1 Answer

vechile idles to low idles to low no codes the idle air control (IAC) probably needs removed and cleaned. this is what controls idleing on most vehicles now days. but do not put entire unit in any ...

Question about 1999 Yukon

1 Answer

...flex plate/fly wheel the truck is a1999 Yukon with 200k This is possible with engine off through a round inspection hole on transmission bell housing you can see the flywheel with a flashlight . now ...

...flex plate two months ago Typically this sounds like a chewed up ring gear or flex plate but if you recently replaced that, the likely culprit is the pinion gear on the starter. It could be chewed up ...

My 2002 GMC Yukon 5.3 Ltd flex fuel won't crank if it's low on gas and on a hill. This was happening when I first purchased the truck from Carmax. They said nothing was wrong but now anytime it low it

2003 GMC yukon 5.3 engine flex fuel no ck engine light on, yet when they go to inspect it it shows 3 inc codes. what can cause this? 3 inc codes ??? 3 incompleat code's.? Not code's - Readiness ...

2000 Yukon, tow/haul mode will not shut off, light stays on, what to do? You will need to take it to a parts store like NAPA and see if they will read the tcm (transmission control module) for codes, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 GMC Yukon
1999 GMC Yukon

593 Questions

2004 GMC Yukon
2004 GMC Yukon

524 Questions

2001 GMC Yukon
2001 GMC Yukon

309 Questions

2007 GMC Yukon
2007 GMC Yukon

326 Questions

1996 GMC Yukon
1996 GMC Yukon

238 Questions

Manuals & User Guides

Loading...