Questions & Answers for: Buick flex plate

...starter stays on. When I put it in drive or reverse it stops. It doesn't happen all the time and I have replaced it. Could it be the ignition switch? flex plate on the back of the torque converter

jack the car up and remove the flex plate cover 4. the try and turn the engine over by the flex plate it should turn easy if it dosen't or will not turn then the engine is seized hope this helps you

in gear it gets quite but than seems like it always wants to go even when foot is on brake??? This sounds like a loose flex plate or flywheel possiable bolts from torque converter to flex plate loose

...flex plate, and yes they do crack/ or the bolts have elongated there holes from not being tight enough and can sound like a knock, a standard transmission has a fly wheel that the clutch contacts to ...

...not due for another 1000 miles. not over heating and no loss of power. could be a cracked or broken flex ...

...flex plate was bending under load and left axle boot has a hole and is leaking Greece. crack in trans?. (also have check engine light on, hole in cat and loose exhaust) was referred for transmission ...

...rear main seal on buick terraza 05 - 3.5 L pull the transmission, flywheel ( torque flex plate). This job is best planned using a workshop manual as it is involved and should not be attempted by ...

...flex plate off a buick road master 92 limited edition and what tools I need To replace the flex plate you should purchase an inexpensive repair manual first off, then purchase an inexpensive tool set ...

...of a 3.8 liter V6 2002 Buick Park Avenue?, Because I'm having trouble removing the engine from the transmission housing.... Did you disconnect the Torque Converter from back of the engine flex plate

flex plate on 96 Buick skylark remove the transmission first ( keep the torque converter with the transmission as a unit ) use an impact gun , remove the crankshaft bolts for the flex plate making you