Questions & Answers for: Oldsmobile Cutlass Supreme flasher unit

...working properly and fuses are good. There are two flasher units,one for the turn signals,and another for the emergency,or 4 way flashers.There is a possibility you replaced the wrong flasher

...flasher unit is on a 95 cutlass cruiser. manual says it is under the left kick panel attached to the steering column you should be able to remove the bottom panal under the dash w/ acouple screws to ...

FLASHER" unit, 1.Turn on Emergency FLASHERS 2. Go under Dash while they are on Listen -for Clicking sound then feel for it 3. Should Be a Silver Round Unit About as Big IN ROUND as Half dollar coin 4.

...unit houses circuit breakers, relays, chime module and hazard flasher. Hope helped (remember rated this help) Good luck. The fuse box is on the right side of the insterment panel. if you open the ...

...unit. The hazard flasher is located in the fuse block.On 1980 and later models, both the turn signal flasher and the hazard flasher are located at the lower left hand and the upper right hand corners ...

...flasher unit. When a flasher unit does this its a sign that it is overloaded - too much wattage. Also just turn the indicator to each side and just check that each bulb is bright an not a dull light. ...

flasher for the 96 olds cutlass supreme located you will find it under the dash on the drivers side it is a cylinder or square unit about 2" long with a connector plug on the top.....hope this helps..

...flasher unit on my 1989 Oldsmobile Cutlass Supreme Should be under the dash just to the left of the steering column, sometimes, if you have 2 flashers, you can turn on the emergency flashers and ...

...flasher unit location, any photos to support the location. Flashers Print The turn signal flasher is mounted in a clip on the right side of the steering column support bracket. The hazard flasher is ...

...flasher are located at the lower left hand and the upper right hand corners of the fuse block respectively. Remove these by pulling them from their connectors. The lower dash panel may have to be ...