Questions & Answers for: fix sticky solenoid

Question about magicolor 2300W Laser Printer

1 Answer

...sticky transport solenoid. Is it worth fixing, or should I buy a new printer? open doors and find these solenoids, clean them and make sure they are moving fine, its not so hard. just step by step ...

Ad

Question about Wheelwriter 6 Series II Typewriter

2 Answers

...sticky print solenoid or the rubber bumper on the end of the print solenoid has deteriorated with age. This is a very common problem with that vintage Wheelwriter. It is an easy fix for a qualified ...

Ad

...screw and then gently activate the lever in and out of park until the problem resolves itself. Inactivity leads to a sticky solenoid. If this doesn't fix it suspect a faulty solenoid. Regards ...

Question about 24 in. 15689 Built-in Dishwasher

1 Answer

...sluggish or non-functioning of the latch. Change the solenoid if it seems sticky and can't be fixed by cleaning the bore and plunger (don't apply oil as it will gum up the operation after a

Question about Color LaserJet 3500 Printer

1 Answer

...sticky. Therefore the solenoid doesn't release and the secondary transfer mechanism isn't activated. I've come across 5 HP3500 printers with the 59.99 error message and have fixed all of them by ...

Question about EPL-N3000 Laser Printer

2 Answers

...sticky solenoid on and printer is easy. Small damping sponge becomes sticky for some reason. Cut a similar size sticky tape and using a tweezer, paste it sticky side of sticky tape or selotape to ...

Question about ML 1430 Laser Printer

1 Answer

...slowly remove the paper, while still holding the tab. Do this until all the sticky stuff comes off on the paper. This should fix the stickiness, and allow the tab to go back out. Thanks and take

Question about ML 1430 Laser Printer

1 Answer

...fix this problem? Please help The shift solenoid pairs, usually 2 pairs, are very sensitive and get sticky with age, causing codes and many driving issues. Take them off and clean them and test them ...

Question about ML 1430 Laser Printer

3 Answers

...solenoid...these solenoids tend to get sticky and will not close all the way allowing fuel to keep flowing into the engine..even when it's off...you can try to clean the solenoid, but i have had ...

Question about ML 1430 Laser Printer

1 Answer

...sticky causing the lever to operate late which causes the jam. As a fix I remove the damping foam and put insulation tape on the lever making sure the solenoid works by using a 12v bench psu before ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66967 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...