...speaker output shorted in one way or another...did you have a speaker hooked up? You most likely blew the output transistors and they ALL need to be replaced as one going bad will kill the rest since ...
Question about Cinema Grand Signature 400 seven 7-Channel Amplifier
output terminals then its best if you dont use the 4ohm speakers at all....just connect the 8ohm to the 8ohm terminals...you dont mention any crossover networks inside the speaker boxes or if you have
Question about 600MSX Car Audio Amplifier
...speaker wires from it. If the light still goes out, check the DC voltage on the B+ and remote terminals. Place the black meter lead on the ground terminal of the amplifier. If the voltage remains ...
Question about MRP-M350 Car Audio Amplifier
...speaker wire the bolt that hooks the ground wire into the battery is stripped it could be intermitting power to the amp but the amp is still getting power just not sending any and none of the fuses ...
...speaker outputs are not working board is burned on the ground side right behind the terminal you probably burned a trace in the event and unless u have the right equipment and tools you probably wont ...
...fix? Not sure if I need to replace speakers or speaker cable or even the amp!! Please help. Thanks. The fault is on the amp! It sounds like the protection circuit is detecting a surge on the channel ...
...speaker output terminals off, if there an easy way to fix that? are they soldered right to the board or can they simply be taken off and replaced? THAT USEUALLY MEANS UR AMP IS WAY 2 POWERFUL FOR UR ...
...fix it? hello, Its usually not a fault that you will see unless somethings burnt up. This is solid state electronics and you dont see this stuff go bad. But in the meantime try disconnecting the ...
fix this? hi, First of all remove all the speaker connections from the amplifier. After that power the amplifier and check the protect show or not . if not, then any of the speaker is damaged. If then
...fix this problem. hi, First of all remove all the speaker connections from the amplifier. After that power the amplifier and check the overload (protect) show or not . if not, then any of the speaker ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions