...FIX: Open the part containing the rollers. You can see a white plastic part which stop the documents feeded into the adf. Lower this part and insert a page into the adf just a bit further than where ...
...printer which was just 6 mos. OLD and FINE by me! So THX, Vikram Kumar Thumu! Paper jam, but no real paper jam. I cleaned the encoder strip per Canon's instruction and fixed it! The flimsy plastic ...
problem. I pulled a hair pin out of it that didn't allow the paper to fall in completely. Try running a stiff piece of paper around teh paper feed area to see if you have anything dropped in there
...to engage with the rollers but the paper is only pulling to one side and jams. looked all over nothing is obstructing area. Clean the paper feed roller and look attention is the mechanical
crooked feeder paper Sounds like the rubber rollers that grab the paper are dirty, and one is not grabbing well. Clean them, and your paper will probably feed correctly.
...printer properly Paper is not feeding into printer. Then I get a paper jam message and there is no jam because the paper is not even loading. Do I need to clean the rollers and if so, how for this ...
...paper jam My 2 years old Canon Pixma MX410 printer tells me that there is a paperjam every time I try to print. There is no paper anywhere, I tried turning it on/off, ... Now I'm trying to find the ...
Question about PIXMA MX410 Wireless All-In-One Inkjet Printer
...fix it. Just check real nothing came into the paper feeder. Not the first time just a paperclip is spoiling all fun. When only one sensor can't sense the paper moving, you get this message. Even when ...
...the LF drive; - remove foreign material. If other solution fail, replace one off the following - LF / EJ slit film - LF / EJ timing sensor unit - Paper feed roller unit - Logic board - Paper feed ...
Question about PIXMA MX410 Wireless All-In-One Inkjet Printer
...for a small piece of torn paper. Clean the rubber feed roller with a soapy cloth. Replace the paper with new from an unopened pack as what you have may be damp. Put it all back together and try
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions