Questions & Answers for: Subaru Impreza how to fit an alternator

Question about 1996 Impreza

2 Answers

FIT REPLACE ALL PART AND MAKE SURE TIMMING BELT IS NOT OUT OF SEQUENCE GOOD LUCK. Remove the rad with fan(s) Alternator belt, a/c belt if equipped. Then remove timing belt covers from the front of the

Ad

Question about 1996 Impreza

1 Answer

i don't know the car will not start and when a friend put the jumper cables on the car it will keep a clicking noise but will not start. once we remove the cables the car shuts off if we try to start ...

Ad

Question about 1993 Impreza

1 Answer

1993 Subaru Impreza My Impreza hesitates when starting, especially in cold weather and I have to pump the heck out of the gas. Sometimes I practically run the battery down starting. I was told this ...

what hoods fit a 98 subaru impreza outback? call wrecking yard they can tell you what years will fit or dealer! good luck!

Question about 2005 Impreza

1 Answer

hi there i have fitted a new hi there i have fitted a new alternator in my impreza as the battery wasnt charging but this alternator has made no difference (still only getting 12.2v) but what i ...

I put a new battery and alternator on my impreza. Just after this my car has had an extremely low idle speed (200-500rpm) and has died when the car was put in neutral. I'm thinking its the TPI sensor ...

Question about 2005 Impreza

1 Answer

my 1005 Impreza only charges the battery when under load (e.g with all lights on). Normal day time driving without loading the alternator cause the battery to discharge to a flat condition. Why? the ...

my battery and brake light came on while driving and the lights get brighter then dim This sounds that it could be one of two problems. The easiest and most common problem to fix is a loose alternator

Question about 1995 Impreza

2 Answers

my alternator is not working, however it tested perfect on a machine. Is there a relay or fuse somewhere that could be blown? I have checked all the fuses, and none are blown. Could be that the volt ...

(about 3' should do.). At one end, drill two holes offset to one edge for some 10mm bolts that will fit in the holes on the pulley. The offset is so you can get a socket on the main crank nut. Fit the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...