...stuck in the filter shaft. Pieces of it have been removed but it is difficult to tell if it is all out or not. should the new grommet fit into the shaft easily? what holds the filter in place? I ...
...filter screws on that is not working or stuck open and letting to much pressure thru. It happend to me 2 times in a week until a friend of mine who had his own shop told me to chk. that valve and ...
...to bottom of the engine. Was the oil and filter changed ?if so pull out filter and see if an chunks are stuck in it now. And change oil and filter again. Sorry that was out of order I had a long ...
...filter, make sure an old rubber gasket isn't stuck on the mating surface, then check the mating surface where the oil filter goes for any imperfections or burrs in the metal that would cause a small ...
...filter is blowing seal on my 1995 chevy silverado 1500 . just changed oil new filter remove the new filter, then remove the gasket from your old filter that is stuck to the engine, reinstall new ...
...I was told it was by the drivers door. It doesn't seem to be there the fuel filter is neer the gas tank..... Follow fuel lines out of gas tank. They meet at fuel filter. Stuck up in bracket by
to a stuck purge valve by the engine. The pressure regulator could be stuck from dirt in the fuel. You could have installed the wrong kind of filter or put it in backwards, so it collapsed and plugged
...stuck on the filter housing. Then when you place the new filter on you have what is called a double gasket. this will cause you to leak oil rapidly. I would remove the filter and check for a double ...
oil filter is stuck r ur filter cartrige or the metal filter
...filter make sure the old gasket didn't come off the old filter and stick to the block.. this happens a lot. There might be an old gasket stuck there and the new one might not be making a good
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions