Questions & Answers for: Hobart feed problems

Question about Hobart Welding Tools

Hobart Handler 175 Wire doesn't feed when trigger operated.

Hobart Handler 175 Wire doesn't feed when trigger operated. Wire doesn't feed when trigger operated. I can hear a clicking noise in the unit, but the wire doesn,t feed and the feed motor isn't running

Question about Handler 140 Mig Welder

1 Answer

Hobart 135 wire feed sped control problem

hobart 135 wire feed sped control problem The wire feed speed control runs at full speed regardless of the knob position. I checked the potenciometer and the ohms vary as the knob is turned but the ...

Question about Handler 140 Mig Welder

1 Answer

I have an hobart welder-handler 150, when the

have an hobart welder-handler 150, when the welder is set to the lowest setting 1 the wire will not feed through, the motor is running but not feeding. When the setting is on 2 or higher it works fine

Question about Handler 125 Ez

1 Answer

My handler 125 has been

...125 has been setting in the garage unused a year or two. i just turned it on and it doesnt try to feed the wire out. any ideas? If you can see the tip of the wire, grab it with a plier, and ...

Question about Handler 125 115 Volt 30 To 125 Amp Arc Single Phase Wire Welding Package #500487

1 Answer

My welder feeds normal for the first 10 to 20 secs

My welder feeds normal for the first 10 to 20 secs then struggles to feed wire. I have replaced feed tube and wire, adjusted tension both ways andput new tips, currently using .035 for.030 wire. I ...

Question about Handler 125 115 Volt 30 To 125 Amp Arc Single Phase Wire Welding Package #500487

1 Answer

I have a IRON MAN 250 Mig Welder. that the wire

I have a IRON MAN 250 Mig Welder. that the wire don't feed, with regularty. I have a miller with the same tourch that dose the same thing. If you pull about 4 or 5 inches of wire out, with trigger

Question about Handler 140 Mig Welder

1 Answer

I have a Hobart 140

I have a Hobart 140 Handler, My Problem is the feed wire is feeding too fast. It can not be regulated with the speed control. I believe the problem is with the pc board but not a 100 percent sure. Hi:

Question about Handler 140 Mig Welder

1 Answer

Hobart handler 135, the wire starts to feed for

Hobart handler 135, the wire starts to feed for about 15 seconds then slows and stops. Hi:Don't know how old is your unit but my guess is that your gun's liner is the problem. Have you change ...

Question about Handler 140 Mig Welder

1 Answer

Wire feed problem with snap-on mig welder

...feed motor. You can try running the motor directly from a 12v battery or two for 24 volts. You might want to look at the name plate on the motor to check the normal DC current it draws. If you do not ...

Question about Handler 140 Mig Welder

1 Answer

I have a Hobart 251 mig welder and when I turn it on the wire comes out of the the gun and won't stop till I shut it off ?

...when I turn it on the wire comes out of the the gun and won't stop till I shut it off ? If the wire feed on your Hobart 251 MIG welder won't stop when you turn it on, there could be a few possible ...