Questions & Answers for: faulty button Cell Phones

It could be that the element is faulty which is why it won't run unless you hold the button in or the electronic control board is faulty or the button is faulty if it's not an electronic model cheers

...faulty touch control (button) board on TV. If instead the TV does not even turn on, then tv is on protection mode, in that case it can be any internal fault. If instead the problem is with remote ...

...button on the panel does not work. possible cause start button faulty does any other buttons work if so door switch faulty or door latch broken if these ok then maybe control board faulty good ...

button is faulty. It will turn on for a short period of time when you hold the button in but then it will eventually shut off. Just wondering how to fix this. It may be the switch that needs replacing

...work and the other buttons will only work occassionally. we have a precour 9.21s hi check the push button (micro switch) for enter. may be it faulty. if found faulty replace it. its a cheaper one. ...

...button goes crazy, cant power on with the power buttons, but other buttons. but sometimes, stable, like NOW. Test your PSU or replace it if your power supply units fan is not working your PSU is ...

button is faulty. Also check the spark plug leads from the distributor to the spark plugs.If the distributor is faulty (ie cracked or there is a carbon track on the inside of the distributor cap) then

...button. 8. Faulty kickstand, clutch, neutral safety switch. 9. Security alarm needs a reset. 10. Starter relay, solenoid, starter motor or circuit wiring faulty. 11. Starter armature or field coils ...

...button simultaneously for at least 5 seconds: the display shows the last alarm.The alarm sequence continues to flash as long as the two buttons are held down. The appliance continues the cycle while ...

...faulty; Rapid reading last alarms: Press the START/PAUSE button and the nearest option button simultaneously (4 and 6) for at least 2 seconds: the LEDs initially switch off, and then display the ...