...ON just cheak ur psu , if supply is ok then short ur on-off switch directly , may be button is faulty . i need i/o diagrhan can you sand me my mail add my mail id is ...
...faulty. Installing a second RAM corrupts the operating system. The reason behind this is that the OS, when installed, detects the hardware present and optimizes the settings for it; in short it is ...
Question about GA-7N400 Pro 2 : ATX Socket A FSB400 DDR400 AGP8x SATA/IDE Raid w/audio Gb-LAN (NEWITEM121760113) Motherboard
button in and then restart. It will be OK for a while, again sometimes minutes sometimes hours. Could it be the graphics card? no i guess itz not the graphics card..itz probably causing from faulty or
...button.i have tried everything but the problem still persist Replace your PSU then test all leads that are attached to your hard drive sounds like a faulty lead of some sorts then try replacing all ...
...button, the system beeps once. The monitor shows the processor name, motherboard name, bios version and bios date. Absolutely nothing else. And the machine freezes there. Can't enter BIOS either. ...
...the letter. Test your PSU or replace it if your power supply units fan is not working your PSU is faulty One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect/ ...
Question about GA-EP45T-DS3R M-b, P45+ICH10R, FSB 1600 MHz, DDR3 1900MHz , PCI-E x16 2.0
...button for about 10 seconds, put the battery in / plug it in and turn it on. If you still can't access the BIOS then you need a new board. One bad lead can cause a computer to continue on a cycle ...
...button so iff i switch it off on the power supply and switch it back on it immediatly starts up not showing anything on screen and it is definetly not graph card Test your PSU or replace it if your ...
...faulty leads will end up with a computer error If your computer came with a motherboard disc the drivers could be on it or you might have a dirty graphics card remove the graphics card and clean the ...
Question about GA-P35-DS3L Motherboard
...button, the screen would freeze, and the computer would then emit a continuous beep. I already took out the graphics card and put it back in, same with the RAM, and I had cleaned the CPU heatsink and ...
Usually answered in minutes!
144 Questions
129 Questions
113 Questions
96 Questions
95 Questions
