...loop should not have fried anything, as I know lots of peeps who have done that. The FM RF amp. sounds like it may be at fault. The only way to tell if its bad is by hooking up an RF generator and I ...
fault, The static noise is coming out of ic720 [ cs4391 or cs4392 ]on digi pcb which is D-A converter this ic maybe faulty, i have ordered a replacement ic and will post here if solves problem Because
...loop can be caused by a broken wire. It is important that every compnent be grounded to a single point. With a broken wire this can cause multiple paths to ground. disconnect everything, all ...
...loop. I have had zero luck getting any of those to receive the signal. Instead i have ran my digital signal to a vcr, then ran rca cables from it to my tv. I then put my tv in vcr mode, or aux ...
...fault in the antenna lead, (common) or bad earth on the antenna to body If you don't have an antenna connected to your FM receiver,With a receiver or tuner, connect a wire-loop or T-shaped dipole FM ...
...fault in the radio sectiion. You can conect a set of wires to the FM loop connection and keep it up , if the signal strength is very good it will give you the signal after a search. Memorise, set an ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions