Questions & Answers for: Jeep Grand Cherokee fault codes

Question about 1997 Grand Cherokee

2 Answers

...for the codes 12, 42, 45, 46. Code 55 is not a fault code as I wrote above. Call a mechanic to correct the Codes, this will reset the car's CEL and make it Fault Free. Thank you Sir, Have a nice

Ad

Question about 2000 Grand Cherokee

1 Answer

...Fault codes are displayed as messages on the tool. Each message will indicate a particular circuit or component. You must then refer to the appropriate diagnostic chart in a service manual to isolate ...

Ad

Question about 1996 Grand Cherokee

1 Answer

codes. Their is a fault with the electronics on one of the vehilces electrical circuits. This will bring up the malfunction indicator light, you will need to see a dealer with an electronics reader to

fault codes for your Jeep below; Jeep 11 IGN reference signal. 13 Fault in the map sensor pneumatic circuit. 14 Fault in the map sensor electrical circuit. 15 Fault in the vehicle speed sensor circuit

I have a code 41 on my 93 grand chorkee 5.2 4x4 Fault Code 41 Description: Alternator field control circuit open or shorted Power loss light: Off Limp-in mode: None Possible Causes * Bad connection or

...sometimes it wont ? Many times its caused by a bad crank position sensor. Sometimes they throw a fault code, but sometimes they donĀ“t. So first check if there is any fault code set in the PCM with ...

Question about 1993 Grand Cherokee

1 Answer

this Greg thanks . how do I clear the code? Clearing CodesPrint Stored faults should only be cleared by use of the DRB-II or similar scan tool. Disconnecting the battery will clear codes but is not ...

jeep shuts down while driving, but will start back up in 1 or 2 minutes Check for a fault code set using keydance: ignition switch off/run three times and leave in run at third time. Odometer will ...

Question about 2001 Grand Cherokee

1 Answer

fault code P0107 in 2001 grand cherokee fault code P0107 Code 107 means the MAP sensor signal is low. The problem could be the sensor, the wiring, or a major vac leak.

Question about 1999 Grand Cherokee

1 Answer

...fault codes and CE in the first place. If you have replaced parts (because some one told you XYZ fault code = replace ABC part) you thought were causing the problems and you are still getting the CE ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...