My Norcold Fridge will not operate on AC My Norcold Fridge gives a fault code of ''A'' when I try to run it on AC. It will run on Gas. I had this happen long time ago but do not remember what I did to
door gasket for the refrigerator where can I purchase a door gasket for the refrigerator portion??? the best source to buy the door gasket is from: http://www.repairclinic.com/ open the link and order
fault code on norcold refer model 640.3 reads "no" "co",how do I reset u must take into a dealer or have a mobile tech to reset the board
...the toilet to be able to inspect. Any advice? Thetford says that the vacuum breaker is usually at fault. I have the same problem. Try changing the vacuum breaker first (it is easier than the water ...
N90 EHLtype C 11 Pilot gas wont stay alight. Thetford Caravan Fridge N90 EHLtype C 11 Pilot gas wont stay alight. Your problem is probably with the thermacouple. Contact a service company.
While working on ac switches to lp with no warning. If the incoming AC voltage falls too low, it does this to maintain cooling capacity. It will also do the same thing if voltage gets too high. It ...
Question about RV Refrigerator - N300 Model - Type - 3-Way
Model 12110 IM Norcold-not cooling on AC or Gas..no fault codes coming up Hi, if the burner lights in the 'gas' mode, the control board is OK. You most likely have a leak in the sealed ...
Question about RV Refrigerator - N300 Model - Type - 3-Way
...now back on home mains problem still persists If switching off and on again doesn't clear fault 8 (ac volts 20% lower than spec) you may need to replace the board for one with a resetting ...
Question about RV Refrigerator - N300 Model - Type - 3-Way
Will a fridge still work if fault code 13 is displayed? We have a Thetford fridge in our caravan and is displaying fault code 13. In the manual it says it goes into (BOS) backup mode. Does this mean ...
Question about RV Refrigerator - N300 Model - Type - 3-Way
...150. Starts on gas fine, then after awhile error code 11. Gas supply is okay, hence is it a thermo couple issue or a new board? • Fault 11: No energy source is available and control is in AUTO
Usually answered in minutes!
108 Questions
45 Questions
26 Questions
16 Questions
12 Questions