Questions & Answers for: Chevrolet Impala far far away

...away, i'm going to have to replace my brakes because i have to ride them so much. the check engine light stays on and in traffic, stop and go i've noticed the temperature gauge rising, but it hasnt ...

...away. If you fix this and replace your blower motor and resistor your HVAC will work correctly again. I spent a year trying to figure this out. Just remove the bezel and check the weather strip. You ...

...thermostat replace it at once. I think its the temp acting up sensor ours just did it but I unhooked the batt. for a min. hook it back up and it went away we'll see if it comes back so far so

...far away from usa so is dificult to get modules i now there is a way whith some resistors and relays it will be good to me if you can send me the diagrams thanks a lot With the car RUNNING (very ...

...of car. maybe a wheel bearing if you are driving and cut the wheel one way the noise should increase cut the wheel the other way noise should go away how far can a car go with a noise wheel ...

...far away to work. Since you also have an ABS warning, I suspect your Brake pads are worn out. The fact that you get a warning when the wheels are turned means the front Calipers are moving alot. The ...

...to ground, usually if you follow the wiring harness it will be evident and not far away from the light. find it, take it apart and clean it, put it back together, and squirt some coating on ...

...away when you shut it off and restart it. It eventually gets worse until it comes on every time you start the vehicle. You have to unplug the speed sensor at the left front wheel, unclip all the ...

...far away I have to sit sooo close to the stearing wheel (less then 10 inches) because the gas pedel and brake pedel are so far away. What is the best way to address this problem? There are blocks you ...

...far away so if you get the wrong size socket just take it back and switch it. In the past, I was changing out halfshaft on different vehicle, bought a new socket for old spindle nut. Turns out the ...