Questions & Answers for: Ford F-250 fan belt

...Fan Belt? We have a R reg Ka which has this week developed a clicking noise in the vicinity of the fan belt. It sounds like something is catching each time the fan belt turns. The rate of click ...

...Need to replace all belts. Powersteering, alternator fan, water pump. Need help. Thanks Bob Get a old leather belt cut it in half . Now put a hole in each cut end and drill it to the back of the

...belt behind the fan then you can thread it over a blade and turn the fan, thus not having to remove the fan. Once the fan issue is resolved or not an issue and you cannot find the threading picture, ...

belt off, spin that idler pulley and see if it turns easily or makes noise. Check if the bearing feels good and smooth or if it wobbles any. While you are at it, check the fan and fan clutch to see if

...Fan belt on 1995 F 250 power stroke desiel. There is a square hole on the tensioner that will allow you to use either a breaker bar or ratchet to release the tension on the belt. If your truck no ...

need diagram for replacing fan belt 7.3 nonturbo the only part of the belt that touches the back side is the idler pully all other pullies are on the inside of the belt

...fan belt(s) so you don't have to worry about the fan or anything in that area turning. You can run the engine for a 2-3 minutes with the belts off it won't hurt anything. Without the fan blowing you ...

...bad it could be the soound of a raditor fan motor or drive belts, if drive belt is noisy then you have just adj the tension of belt and if it is of radiator fan then check the relay of fan.

...belt on till u get fan off if your going that deep if not fan threaded on u will see big not thay makr a tool to get the fan off might can rent if not long cheisel an hammer will work just not the ...

...fan belt replaced and now getting a loud high pitched vibration noise when accelerating it occurs between 1000 and 1500 Rpm and goes away at higher speed and rpm and noise at idle, and occurs Also in ...