Questions & Answers for: Chevrolet failsafe

...that trany cools 1st check tranny fluid level if good tranny needs to be rebuilt it will go into failsafe mode when the computer sences to much ...

...w/ coolant sensor fail(low temp) indication.--- 65,000 miles on vehicle. Change the thermostat. Failsafe ones lock open rather than closed to save the head gasket. Or you can hold the battery ...

...on the blower motor or under dash near floorboard,,,some of the circuits blow out and goes to failsafe mode and blows on one speed only...go to parts store and tell them whats happening and

...having problem what can it be? Igniton switch can cause that. The ecu is putting your trans in failsafe mode.  Have it scanned for dtc codes.  If it starts off properly then goes to ...

...to the floor while cranking the engine, keep your foot planted while turning the key, this is a failsafe start operation - it will clear the cylinders with no fuel for a second or two then slowly ...

...be stuck open If it rouns cold below 195 it's stuck open...cheap replacement cost make sure it's a failsafe premium tstat and be VERY careful when you tighten the 2 housing bolts back in ...

...car will not start. turn the ignition on and leave it on for 15 minutes (not a misprint)-this is a failsafe way of bypassing the security system. Don't short change it, make sure it is OVER 15 ...

...power) #3 - Computer detects slip after about an half hour of highway speeds and engages the FAILSAFE which applies MAXIMUM LINE PREASURE to push the fluid to the transmission although this ...

my ford explorer 2005 has a engine failsafe mode when i was driving my car it started to stall and the engine failsafe mode can on as will as check engine light then it just stopped. I turned off the ...

failsafe mode Won't crank over. Tried all the keys. Lock light is on. Sounds like the body control module(BCM) has died. Do a relearn. Turn the ignition on (don't try to start) for ten minutes, turn ...