Questions & Answers for: external resistor coil wiring

Question about (PSS26MSRSS) Side by Side Refrigerator

1 Answer

...external fan. If not, you may need an evaporator fan motor. Also check board in back for burned resistor. May need to replace both. If that fan IS running, remove lower rear wall of freezer and ...

Ad

Question about (PSS26MSRSS) Side by Side Refrigerator

1 Answer

...external coil get power.There are 4 prongs on top of the coil. the two in front go to the distributer.I assume something plugs into the back two for the power. problem is my harness seems to be ...

Ad

Question about 1966 Mustang

1 Answer

...HAS POST MARKED "+" & "-"....CAR WILL RUN BOTH WAYS BUT MAY BE DAMAGING POINTS AND EXTERNAL RESISTOR,IF WIRED BACKWARDS. negative to the points, positive to the hot wire that goes to the

No ignition getting to the coil. i assume that since it is an external resister coil and I don't see A resistor anywhere that there must be one in the wiring. You are correct on this.

Question about 1990 Ram

1 Answer

...resistor ( 0.6 ohms) and new point set, gapped to 0.016" There are 3 wires coming from the harness , 1is hot from ign. switch, the 2nd to the tach, the 3rd from or to ? Maybe wiring is hooked up ...

Question about 1990 Ram

1 Answer

...external resister Simple solution will be to run a wire from the ignition "on" position to the resistor and then from the resistor to the coil positive. Then run a seperate wire from the ignition ...

external ballast resistor and externally resisted coil. We do not have wiring diagrams here at fixya, the manuals are copyrighted material I did find this one picture with numbered wires that may help

Question about 1990 Ram

1 Answer

...external resistor. ask at the parts store for a resistance type coil. should be the fix 4 ya or it might be a wiring problem standard coil uses the full 12v and after it starts it cuts the voltage ...

...external resistor coil, you must now run a wire from the ignition switch "on" position directly to the distributor to supply full 12 volts. All of this depends on what you are working on so now don't ...

...test is to replace with known good unit. Older cars have two types--internal resistor and external resistor. Also note coils have a polarity which must be wired correctly or fuel milage will

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you a Refrigerators Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...