Question about 10-0034 Switch-Mate Pump Float Switch with 15' Cord
...extension cord that you are comfortable with cutting. Cut one of the 2 wires of the extension cord, and put the float switch in-line on this one cut wire. Be sure to use wire nuts or ...
Question about 10-0034 Switch-Mate Pump Float Switch with 15' Cord
sump pump float adjustment How far above the drain tile should the water level be before the sump pump turns on? This really depends entirely on you. the higher the water level the less frequently it ...
Question about 10-0034 Switch-Mate Pump Float Switch with 15' Cord
Am I correct in assuming that the float switch is wired in on the hot wire before the pump? (Hardwiring without use of piggy-back) Yes, this is correct. For future reference, switches should always be
Question about M53 Mighty Mate Iron Body, Poly Base Automatic Sump Pump 1/3 HP
i have a 1/3 hp 9.7 amp 1 phase zoeller sump pump plugged into a 20 amp GFCI receptacle.has worked fine for 2 years then abruptly started tripping the GFCI as soon as the pump kicks in. This a ...
Question about BN53 Mighty Mate Iron Body, Poly Base Non-automatic Sump Pump W/ 1
hi, i have m267-f sewer pump. when i plug it in , pump blow out electrical breaker. what the problem? There may be a crack in the power wire or around the seal where cord goes into the pump.It is also
Question about Sump Pump with 25 foot cord 2" 1/2 Horsepower M267-0006
zoeller m267-f pump has power going to the motor but will nut run Does it have a float switch? Does the motor run when you lift the float switch? If not... then the motor's gone.
Usually answered in minutes!
3 Questions