Questions & Answers for: eureka whirlwind lite

...say which brand and model number you have, and they are different. Belts go around the brush roll and the motor shaft on most models. an eureka whirlwind lite /the boss how to open to get at the ...

eureka lite speed, belt is a U thanks There are 2 screws on the top cover, remove those and the cover comes off, then you can get to the brush roll and belt. Inspect the brush roll, make sure the ends

...Eureka Whirlwind Lite Model 410 bagless vacuum due to an excessive amount of debris that collected in an inconspicuous spot and now that I've reassembled it it sounds like something from the motor is ...

...eureka upright the boss whirlwind lite and i need to change the belt. I have no clue where to find it. Need help with this If you torn the macine over, at the bottom of the sweeper you will see the ...

Eureka whirlwind lite model#4388 I am assuming that you're looking for the handle at the front of the dirt cup... Part # 28131-288N, it has been replaced by part # 74985 Dirt cup grip assembly. If you

EUREKA THE BOSS WHIRLWIND LITE CYCLONIC POWER CANISTER TYPE VAC. THE HANDLE IS DETACHABLE TO CLEAN IN THE CORNER WITH A SMALL EXTENSION. i have never heard of any belts in a vacuum cleaner You can get

...Eureka Lite speed whirlwind has a bad odor when it runs. Our Eureka Lite speed Whirlwind has been used to vacumn dog hair etc and now it stinks when I start it. I think i need a new hepa filter and ...

...Eureka Whirlwind Lite "Boss" model 450 A Please provide instructions as I am at a loss as to where to open to get in to replace the belt. Thanks Fred Remove the 4 screws on the yellow top of the ...

...Eureka Whirlwind Lite 12 amp vaccum? There are two filters for the this vacuum. The first goes behind the dump cup and there is a filter pack for that below. Filter Value Pack. Eureka Part #60951A - ...

how do i change the belt in the boss whirlwind lite Remove 4 screws on top and remove this cover. Belt and roller are easily accessable.