...button the light flashes but want enguage. you cabn here it under the truck switching . Replace the encoder motor sensor and or encoder ...
...low. Sometimes it works fine. What to do? Just serviced my own 4x4 Suburban, by buying a 2nd hand encoder motor and replaced the old one, which was trashed by the winter salt. The device is prone
gmc 1500 z 71 encoder Does anyone know where I can find a 4wd encoder motor position sensor. I live in canada and the dealer wont's $250. The gm part number is 88962315 www.gmpartsdirect.com Not sure ...
...replace if the fuse is bad. If the replacement fuse goes bad again, check the wire harness at the encoder motor on the transfer-case. Look for any damages causing a short making the fuse to go bad, ...
...tool and read the transfer case service codes to see what is actually wrong. I do see a lot of bad Encoder Motor Position Sensors and bad encoder motors so that's my initial thought on what might be ...
...longer switch into 4x4 mode. you need to scan transfer case module for codes, i have replaced many encoder motor sensors donot replace entire encoder ...
...switch indicators 2hi, 4hi,4low . Check fuse #6 10amp I/P fuse panel . DTC 002 The transfer case encoder motor is an assembly which houses four separate channels. These channels are used to ...
...to 4wd, the switch wont work. The 4wd does work, but its having a hard time switching. either the encoder is bad or the complete encoder motor assembly. this motor and encoder is mounted on the
Fault code co327 what to do 4x4 not ingaging panel lights of DTC C0327 Encoder Circuit Malfunction - you have a electrical circuit problem ! I suggest you take this to a ASE certified repair facility
transfcase motor not shifting 2007 Tahoe ltz. originally got stuck in 4low and I had to remove the encoder motor and manually shift case into 2hi. I then drove without a encoder motor on transfer case
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions