emule Why do I receive a low ID when using eMule through my D-Link router? There are several reasons why this is happening. Most likely the reason is simply because you are behind a router or firewall
configure for emule How do I configure my router to use eMule? You must open ports on your router to allow incoming traffic while using eMule. eMule uses three ports*: 4662 (TCP) 4672 (UDP) 4711 (TCP)
low ID on eMule Why do I receive a low ID when using eMule through my D-Link router? One more thing re low id on emule - try to choose ports between 10000 and 60000 - many isps block the standard ...
Emule lowid Sir I have Microsoft window Vista home premium and Norton Internet security. In Emule I am getting LowId. I have opted for Norton Firewall. But I have configuered in Both window Vista and ...
Question about AirPlus DI-614+ Wireless Router
emule connection problem , DI- 614+ revB router whenever i connect emule , the internet connection is down after a few minutes. i forward 4662 TCP and 4672 UDP. my DLink router have latest firmware ...
Question about ADSL2/2+ Modem/Wireless Router 4-Port Switch, 802.11g, QoS (DSL-2640B)
to activ wireless router Check out the emulator http://www.support.dlink.com/emulators/dsl2640b/306041/vpivci.html the gateway ip is 192.168.1.1 the username is admin password: admin Thanks for using ...
instalation Hi Visit the emulator link below http://support.dlink.com/emulators/di704p_revB/hwiz.htm Once you open the link you would see the username and password screen, click ok and there you would
Question about DIR-685 Wireless-N 300 MBps Router + 4-port Switch (790069320859)
open port for emule Hello The web site mentioned below helps to configure the port for emule http://portforward.com/cportsnotes/emule/eMule.htm Hope it helps, if so do rate the solution Good Luck
...internet connection since swapping to d-link wireless router, i am using channel 11 1. There is a emulator on the D-Link site that will walk you through the set up for your model router. 2. When ...
unable save settings DIR 600 When I try to save settings, emulator, http://www.support.dlink.com/emulators/dir600/101NA/wan_dhcp.html I get this message: "This feature has been disabled on this ...
Usually answered in minutes!
1,082 Questions
984 Questions
709 Questions
641 Questions
532 Questions