Questions & Answers for: Mitsubishi eject cassette

...the cassette before the eject sequence, is getting caught inside the player. Let me know if I can be of further assistance to you. Good luck! - Jim I'm looking for the solution to this problem! ...

Plays for 3 secs, stops, and then ejects Mitsubishi HS-U62 S-VHS. DJ4+Twin Fe super VHS. I put the tape in, it plays for 2-3 seconds, it stops & then ejects. Ugh! This unit needs to have the "idler" ...

...cassette loading slot and while the Power button comes on and I try to eject the tape, since it wont come out or eject, the Power goes out and shuts off. How do I get the defective tape out???? If ...

VHS Cassette stuck will not eject take the cover off. try to locate the loading motor and turn the gear on it and the tape will slowly eject.

It ejects the tape immediately...and then it powers off. older VCR--I have one like it. You need to remove top cover and bottom shield, look for one of the belts to be either broken or off. There are ...

eject. Does any of this make sense? . Mine did that, and when I opened it I found that a small drive belt (visible from the bottom with the cover removed) had deteriorated into goo. This unit had

...eject this should remove the cassette without difficulty. If all this fails the problem lies in the vcr itself, a bad idler assembly, broken drive belt, or loading basket problem which will require a ...

...eject, the drive belt will probably need replacing that is attached to the assembly. Quite often it is a cassette problem. The two winding reels run on plastic bases which often becomes very dry and ...

...eject cassette will partially eject, repeated pushing of Eject button will sometimes work, but usually not Needz fresh belts. You can order common o-ringz uv the same length that will work fine, but ...

...on VCR Machine looks pristine inside, no visible burned or smoked areas. Loading carriage takes and ejects casette okay. Your Mitsubishi VCR HS-U580 looks to have a problem with the information ...