...SHOULD REPAIR? hi code 21 (ECT) ENGINE COOLANT TEMPERATURE SENSOR harness and connector OR (ECT) sensor code 24 (VSS) VEHICLE SPEED SENSOR ] harness and connector OR (VSS) sensor WITH MY BEST ...
...ECT)coolant temp sensor have two wire and you can test it by (AVO meter) the two wire :- the 1st is ground from ECM the 2nd is have 5 volt whine disconnect the connector of (ECT) and less then whine ...
lead into the intake manifold. When you finish fill up with one tank of Chervon to clean out the injectors. Try to get a toque wrench and tighten ever bolt on the valve cover back to specification. If
...GSI petrol. Automatic. When cruising at 4o mph it starts jerking and seems like it has a problem selecting the right gear. Also at around 60 mph it jerks when I accelerate. My experience with Hyundai ...
ECU of my Hyundai Scoupe 1994 2 doors cannot trigger the sequence of the fuel injectors to supply gas or petrol into the combustion chambers but spark is available to the spark plugs! can you help me ...
i have put numerous parts on a 1995 coupe 1500cc i have put numerous parts on a 1995 cope 1500cc turbo but still having problembs starting from cold in the mornings, it will fire but will not kick in ...
I have 1 car hyundai scoupe 1995 model, my problem is ; 1. Can't run the car because no spark produce; 2. I all ready change the spark plug, cable plug and ignition coil but still can't run. Crank ...
...engine light came on then off about three times before this occurred. Car has fuel, checked injectors, fuel pump, plugs, rotar. think it might be crank shaft sensor? You stated the 'CHECK
Question about Motor 1992 Scoupe
1992 hyundai s coupe 1.5l eng fuel to injectors but injectors not firing what triggers injectors The injectors are grounded by the cars powertrain control module (called the PCM for short) at the
1994 Hyundai Scoupe will not go into overdrive transmission sensor or you may need to change the transmission filter
Usually answered in minutes!
45 Questions
15 Questions
18 Questions
14 Questions