Questions & Answers for: Chrysler ect sensor

...ect sensor 3.disconnect ect sensor 4.remove ect sensor and to reinstall 1.install ect sensor torque to 168 in-lbs 2.connect sensor electrical connector 3.connect battery negative terminal 4.refill ...

ect to yours. as well as checking the car when its cold and when its hot. but first for your trouble and safety put a new crank sensor in and have its resistance checked against the new one. I take it

ECT) sensor (3) on the 5.7L engine is located under the air conditioning compressor. It is installed into a water jacket at the front of the cylinder block. WARNING: HOT, PRESSURIZED COOLANT CAN CAUSE

...of the ECT sensor for your vehicle... Guru........Saailer Look for a sensor near or at housing for top rad hose. Follow top hose to where it attaches to engine and you should see a sensor close

...Sensor (ECT)Voltage Low".  The ECT is a thermal variable resistor.  The Powertrain Control Module (PCM) sends a 5 volt reference to the ECT and measures how much of this voltage returns to ...

...sensor or new ECT sensor. They both work hand and hand. If the ECT data reads negative 40 you are under the sea and are flodding out. If the baro is toooo low you get the same result. Hope this ...

...ECT) sensor reading, and the speed of the vehicle. A code P0128 may mean that one or more of the following has happened: Low engine coolant level Leaking or stuck open thermostat Faulty cooling fan ...

...ECT) sensor is threaded into the thermostat housing just below the coolant outlet connector. The ECT sensor is a negative thermal coefficient sensor. 2.7L Engines The Engine Coolant Temperature (ECT) ...

Where is the engine coolant temperature sensor located on a 2007 Chrysler Pacifica 4.0 engine? The coolant sensor (ECT Sensor) is the two wire sensor that is next to the thermostat housing.

ECT sensor it is, and the location is gen4 location, only, for years stated below. only my most !


2002 actual
3.3l ONLY (gen4) 2001 to 2007 are the same why.(location)
ECT SPOT?