...trim ring around the back of the speedo housing. You could use a black permanent marker to cover any scratches. Plug the unit back into the dash and reinsert into your gauge opening. Hopefully all is ...
...trim nor has the door opening mechanism separated from anything.... Not easy to explain - but I basically need to get access to the window mechanism so that I can re-sit the window in the groove ...
...easy to do but you will need a triple square 10mm bit (autozone or napa carries them) Remove front plastic trim piece by pulling forward Using triple square bit unbolt the front two bolts Tilt seat ...
...trim is to allow the headliner to be gently pryed down at the rear. Picture 11 shows the grab handle being removed... Do this on both sides. The screws are T-20 torx. Picture #12 is of the white ...
...easy, as there are a few complicated maneuvers involved, like re and re the door handle, as well as setting up the new actuator. If you decide to continue, you have to be careful removing the outer ...
Usually answered in minutes!
264 Questions
209 Questions
239 Questions
165 Questions
145 Questions