...shot and needs replacing. Advised "Big End Bearing" was damaged. However, have since been advised that if this was so, pistons should have appeared out the sides of the motor by now... Anyone got any ...
...shot on alternator nut on shaft is tight but pulley is loose and slipping. Are pullyies available? Easy way to remove? easy way is take it to the rebuilder and thaey will also re use the original ...
Easy fix to burning oil. Had it be the case on multiple older vehicles. No leaks, just burning. If you have a real old, loose engine all gummed up with dirt and oil all over the place, synthetic might
...shot, you will replace everything while you are in there. No sense taking it apart and then doing it again in a couple months. It is a fairly easy job, the tranny comes out easier than most people ...
Usually answered in minutes!
447 Questions
411 Questions
381 Questions
354 Questions
317 Questions