...E1 - Touch Pad (Keypad) Cable Unplugged - Check the connection between the touch pad (keypad) and control board (clock) to make sure it is secure. Select the 'cancel' function and wait 60 seconds. If ...
Question about Architect Series KEMC308KSS Electric Double Oven
...E1 means. According to this page, it is a control panel malfunction. It may be caused by a shorted wire, but it may just be the control panel malfunctioning on its own. Ledgestone Technologies has ...
my oven does not work has e1 f2 code Usually it means for whirlpool that a keypad cable is unplugged. Oven repair in Mission Viejo, CA Appliance repair in Mission Viejo and Orange County, CA
Question about KEBC207 Electric Double Oven
...E1 Keypad cable unplugged 1. Check keypad connector for firm connection (keypad connects to control board). 2. Press CANCEL. If error code returns after 60 seconds, replace keypad (also called touch ...
...E1 Keypad cable unplugged E1 F2 is a "Keypad Tail Disconnected" error. This actually means the keypad has failed and cannot be detected by the control board (unless it has been unplugged from the ...
Question about 30" Self-Cleaning Freestanding Electric Range - White-on-White
...E1 means that an error with the keypad has occurred. Usually it happens due to loose ribbon cable on the keypad or the electronic control assembly itself going bad. To resolve this issue first, ...
...cable for connection E1 F2 on this unit means the control board has determined that the keypad is faulty. These are not available from the manufacturer, but you can find a replacement membrane switch ...
...e1 f2 code there is a plastic ribbon cable that plugs in to the electronic control on your oven it needs to be unplugged possible lock tab on this and cleaned with denatured alcohol let dry and ...
Question about RBS245PDS Electric Single Oven
...E1 error. Replaced the switch membrane and also the Control board. The error still shows up. Ledgestone Technologies has replacement keypads for NO LONGER AVAILABLE Whirlpool and Kitchenaid models. ...
...E1 and F2 codes. Greetings, This might indicate a bad keypad or that the cable connecting the keypad to the chip board within your whirlpool has come loose. You might need to work with whirlpool to ...
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions