Questions & Answers for: Chevrolet Uplander dust in my house

thermostat where is the location of the thermostat in a chevy uplander 2006 the thermostat is located in the housing attached to the intake on the reare of the engine just follow the upper radiator ...

im looking for the location of the temperature cooling sensor on a 2007 chevy uplander engine and cant find it. it is under the t-sat housing on drivers side of engine.there are two wires going to ...

Rear wiper motor does not work It is possible to fix the problem; it is not the motor itself - the shaft/housing gets corroded and eventually seizes. Remove the wiper and bolts from the outside and ...

how to change ignition switch How do I change ignition switch the electrical part not key and tumbler REMOVE THE STEERING COLUMN HOUSING. LOOK AT A CONNECTOR ON THE LEFT SIDE OF THE HOUSING YOU JUST ...

How do i replace the front turn signal bulb on my 2008 chevy uplander it looks like I need to remove the front lamp assembly first. I got two of the connections off ( the bolt on top and the locking ...

...trailblazer (as far as I know they are the same), See note below for passenger side. Remove the dust cover on the back of the head light assembly (black round rubber cover about 3" in diameter, ...

how to replace thermostat On most cars, follow the upper radiator hose back towards the engine block. Where the hose attaches to the block is a domed housing. The thermostat should be under that ...

how to install ignition switch follow these instructions: Removing the Old Ignition Switch 1. Remove the steering wheel housing. This will be held on by two screws. One will be in the front and the ...

...ago. I first noticed the "rust" about a day or 2 later. He said it's just rail dust. Since then, it's only spread & gotten worse. It's all on the plastic ...

Thermostat housing on a 2008 chevy uplander 3.9 liter This repair is tedious. You will find the thermostat housing located directly below the throttle body. It is tightly set between the engine block ...