Question about Reference 1600a Car Audio Amplifier
...dual voice coil and the voice coils of both are wired in parallel then the load become .5-1 ohm and the amp is unstable (solution) wire 2 dual voice coil subs individually one from each terminal, and ...
...dual voice coil to a fasgate 250a2 amp. how is the best way to get the best sound dual 2 or dual 4 dual 2 wire vc's in series for a 4 ohm load each. Hook each speaker seperate channels on the amp. ...
Question about 1250w Car Subwoofer
...dual voice coil sub. It is probably a dual 4 ohm voice coil. If you hook up the left channel to one input and the right to the other you can safely push the sub but the amp will be running at a lower ...
Question about KAC-9103D Car Audio Amplifier
...dual 4 ohm voice coils, it would be best to wire the voice coils in parallel for a 2 ohm load and connect the sub to one set of terminals on the amp. If your sub is the model RSdC122 with dual 2 ohm ...
...voice coil, dual oice coil. your amp is no lower than 2 ohms stable mono. the proper way to wire this so that you do not burn out the amp is to run the 2 vioce coils in series. run the positive lead ...
...dual 2ohm voice coils will drop the amp to 1ohm if parallel and will kill it. The cleanest possible way to run this amp and keep it cool with lots of headroom is to run the coice coils in series then ...
dual voice coil alpine type x is blown, apparently it was only wired in and only one voice coil was hooked up? they best way to do this is with a multi meter on the OHMS setting.... to do this set the
...dual voice coil sub or a single. As a rule, if the sub has a dual voice coil (2 sets of connections) then connect the 2 positives together and the 2 negatives and run the 2 sets of cables to one ...
...dual voice coil subwoofer. This means that you have to have power to both voicecoils or risk damaging the voice coils. Subs are designed with dual voice coils to give it more control over the cone ...
dual voice coil subwoofer, the sub has 4 speaker wire connections coming out the back how do i bridge it two one You have two choices of how to wire this sub. First, is an 8 ohm load. This is called a
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions